Laser cutting machine safety use precautions enterprise style

1. Observe the safety operation regulations, and turn on the laser cutting machine in strict accordance with the laser start-up procedures;

2. The original laser cutting machine operator should be professionally trained and familiar with the structure and performance of the equipment as well as the operating procedures and control panel;

3. Wear the required protective gear when operating the machine, in the operation should avoid laser damage to the eyes, should wear protective glasses;

4. Some materials need to be handled with care, do not arbitrarily process certain materials without finding out whether they can be produced by the laser cutting machine, so as to avoid the emergence of toxic fumes and potential hazards;

5. When the equipment is working, the operator shall not leave the workstation or entrust someone to take care of it without permission, and it should be disconnected or shut down;

6. Fire extinguishing facilities should be placed within reach, and switch off the laser or light gate after processing is complete;

7. machine studio, do not place around the paper, fabric and other flammable items to prevent fire;

8. The operator should be required to have the ability to adapt, processing, if there is an abnormal situation, should immediately stop, troubleshooting or repair in a timely manner;

9. In the laser cutting machine before and after the use of the equipment should be checked to ensure that the machine's surroundings as well as their own safety and norms, to facilitate the machine to work;

10. The use of gas cylinders should avoid crushing the welding wires, resulting in leakage. The use and transport of gas cylinders should comply with the gas cylinder monitoring procedures. Cylinders should be protected from exposure to the sun and placed near sources of ignition, and the operator should stand to the side of the nozzle when it is activated to avoid accidents;

11. Maintenance of the equipment should be carried out in strict accordance with the high-pressure safety regulations;

12. After switching on the machine, the machine should be driven manually in the X and Y directions at low speed to check whether there is any abnormality in the equipment;

13. for new workpiece program input, should do a trial run, and check its operation;

14. Equipment should pay attention to the stability of the machine when working, should check in advance whether the machine is fixed to avoid slipping off the collision;

15. Equipment should be regularly maintained, daily, weekly, monthly, semi-annually should be large and small maintenance and repair.